I started with a blended cane of polymer clay and cut it into equal sections, removing every second one and keeping both piles in order, so I could do both sides of the bottle the same.
I started at the bottom of one side, pressing the little cylinders I had cut into teardrop (dragon scale) shapes and beginning to layer/stagger them.
Next I made the "label" for the front of the bottle, mixing a couple colors of clay and rolling it smooth, then distressing it. I used rubber stamps to do the letters and added the embellishments by pressing them right into the soft clay. After baking the bottle to harden the clay, I rubbed some brown acrylic paint over the label and allowed it to pool in the indented areas while wiping it away from the smooth parts.
For the bottle cap, I covered the entire cap with a thin layer of clay, making sure that it covered all the metal but not letting it extend too far below the cap, so the bottle can still open. I pressed a plastic gem into the center of the top, then added the four "claws" to hold it in place. Thanks to the fact that polymer clay is baked at such a low level, the plastic gem was not damaged by the heat from the oven.
After baking, I used two colors of floral wire to decorate around the bottle neck.
I also added a little dragonfly brad to one side before baking the clay.
